ENGINE HEAD MACHINING

The cylinder head is the most complex assembly of the engine part. The cylinder head contains valves (intake and exhaust), valve guides, valve seats, springs, valve lifters (mechanical or hydraulic), camshaft (camshaft) one or two, nozzles diesel) and atria (in older diesel engines).

In order to get the speed of service, we have a machining center for the cylinder head. The cylinder head is very complex, the motor power is obtained through the cylinder head. There are cast and aluminum heads with 3 or more cylinders, as well as engine heads with 2 and 4 valves per cylinder. The cylinder head is very sensitive to overheating, this happens if the engine runs out of coolant and a gasket splashes between the water or compression space at the junction with the engine block. Not only is overheating a sore point on the cylinder head, it can also be damaged if you skip the belt or chain that serves to distribute the ignition.

In order to get the speed and quality of service, we have a machining center for the cylinder heads.

Auto Centar ANĐELKOVIĆ, has machines for processing cylinder heads, machines for processing valves, machines for processing valve blades, vacuum test for checking valve sealing, table for assembling cylinder heads and hydro test bath for checking cracks in the cylinder head as well as a sandbox for cleaning exhaust channel.

MECHANICAL DEPARTMENT WITH MACHINES FOR PROCESSING AND ASSEMBLING HEADS ENGINE